Using cancel7drain, To cancel a cycle, To clear the indicators – Whirlpool 940 User Manual
Page 13: Using cancel/drain
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SETTING THE CONTROLS
CYCLE
A shows what each cycle includes
WASH RINSE
MAIN
WASH RINSE
FINAL
RINSE DRY
CYCLE
TIME
(Minutes)
POTS-N-PANS
Double wash for maximum
cleaning of cooked-on or
baked-on foods.
• The water heats to 140°F
(60°C) in both washes
(marked^).
• The water heats to 140”F (60“C) in
the final rinse (marked ^).
•tt
76*
*Cyd« lima indudss diy lim« and may ba longer depending on the temperature ot water entering the dishwasher.
The cooler Ihe water, the longer the cyde time. If the water is aiready hot enough, the cyde times will be as shown.
Using CANCEL7DRAIN
Press CANCEL/DRAIN to cancel a cycle or
to clear the indicators.
To cancel a cycle:
• Press CANCEL/DRAIN while the dish
washer is running to start a 2-minute drain.
It will take a few seconds for the drain to
start. If desired, select a new cycle. (See
“Changing a cycle or option setting” on
page 14.)
• You can press CANCEL/DRAIN again to
stop the drain immediately. Remember to
drain the dishwasher again before starting
a new cycle.
NOTE: A small amount of water remaining
in the dishwasher is normal.
To clear the indicators:
Press CANCEL/DRAIN before starting the
dishwasher to clear all cycle and option
selections.
13