Whirlpool 2194182 - Manual (Page 5)

Before Using Your
Refrigerator
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it, and level it.
Cleaning your refrigerator
Removing packaging materials
Remove tape and any inside labels (except
the model and serial number label) before
using the refrigerator.
To remove any remaining tape or
iabei giue:
• Rub briskly with thumb.
OR
• Apply liquid hand-dishwashing detergent to
area before removing glue as described
above. Do not use sharp instruments,
rubbing alcohol, flammable fluids, or
abrasive cleaners. These can damage the
material. See “Important Safety Instruc­
tions” on page 3.
NOTE: Do not remove any permanent
instruction labels inside your refrigerator.
Do not remove the Tech Sheet fastened
under the refrigerator at the front.
Cleaning it before use
After removing all packaging materials, clean
your refrigerator before using
it, if necessary. See cleaning
instructions on page 23.
Leveling it
Your refrigerator has 2 front leveling screws
- one on the right and one on the left. To
adjust one or both of these, follow the
directions below.
1. Remove base grille. (See page 20.)
2. To raise front, turn screw clockwise.
3. To lower front, turn screw counter­
clockwise.
4. Check with level.
5. Replace base grille. (See page 20.)