Whirlpool SB160PED - Manual (Page 33)

TROUBLESHOOTING
PROBLEM CAUSE
Burner fails to • The oven is not wired into a live circuit with the proper voltage,
light (See Installation Instructions.)
• You have blown a household fuse or tripped a circuit breaker.
The Self-Cleaning
cycle will not
operate
• The clock does not show the correct time of day. (See page 11 for
setting information.)
• You have programmed a delayed start time. Wait for the start
time to be reached.
The cooling fan
does not shut off
after the Self­
Cleaning cycle is
completed
• The electronic controls have not cooled enough. The fan will only
shut off after electronic controls have cooled. Canceling the Self­
Cleaning cycle will not turn off the cooling fan.
Cooking results
are not what you
expected ’ The oven is not level. (See Installation Instructions.)
’ The oven temperature seems too low or too high. See “Adjusting
the oven temperature control” on page 15 to adjust oven tempera­
ture.
• You did not preheat the oven before baking (if called for in
recipe).
' You are using a recipe that has never been tested or is not from a
reliable source.
> You are using a pan that is not the correct type or size. Refer to a
reliable cookbook or recipe for recommended pan type and size.
• There is not enough air space around pan when baking. Allow 1V 2
to 2 inches (4-5 cm) of air space on all sides of pan. There must
be a minimum space of 1 inch.
• If broiling, you have not completely closed the oven door. The
broiler provides the best cooking results with the oven door
closed.
If none of these items was causing your problem, see “Requesting Assistance or Service” on
page 34.
33