Whirlpool SB160PED - Manual (Page 10)

USING YOUR OVEN
The electronic oven control
Display
(see below)
TURN
TO SET
Cancel
button-
(p. 12)
Timer on/off
button
(p. 12)
O 0‘0 O
U U’U
™
DELAY BAKI
DELAY BAKE CLN STOP TIMER CLEAN LOCKED
TIMER CLOCK BAKE STOP CLEAN BROIL BAKE
ON/OFF TIME TIME TEMP
-Set knob
(P-11)
Preheat
button
(p. 13)
Clock
button
(p. 11) Bake time
button
(p, 20) Stop time
button
(p. 22)
Display/clock
• When you first plug in the oven, the time
display will flash until you set a new time.
If, after you set the clock (page 11), the
time display again flashes, your electricity
was off for a while. Reset the clock.
■ When you are not using the oven, the
control is an accurate clock.
• When you are using the oven or Minute
Timer, the display will show times, tem­
perature settings, and what command
buttons have been pressed.
• When showing the time of day, the
display will show the hour and minutes.
• When you are using the Minute Timer,
the display will show minutes and seconds
in the following sequence:
-For settings from 0 to 1 minute 55
seconds, the display will increase in
5-second amounts and count down
each second.
-For settings from 2 minutes to 9
minutes 50 seconds, the display will
increase in 10-second amounts and
count down each second.
-For settings from 10 to 59 minutes,
the display will increase in 1-minute
amounts and count down each second.
-For settings from 1 hour to 1 hour 55
minutes, the display will increase in
5-minute amounts and count down
each minute.
10
Clean button Broil button
(p.26)
(p. 16)
Bake temp
button (p. 14)
-For settings from 2 hours to 9 hours
55 minutes, the display will increase in
10-minute amounts and count down
each minute.
• When you are using Bake Time,
the display will show hours and
minutes.
Command buttons
o o o o o o o o
The command buttons tell the oven what to
do and in what order. A few examples:
-Clock tells the oven you are going to set
the clock.
-Cancel tells the oven to turn off.
Each command button (except Cancel) has
its own Indicator Light on the display. The
Indicator Light comes on when you press the
command button.