Whirlpool LCR5232DQ0 - Manual (Page 5)

Washer Installation
Permanent or portable installation is available for your washer. Instructions and kit numbers
are detailed in this section.
Permanent installation
This washer can be converted from portable
to permanent. Instructions for permanent
installation come with the washer.
You will need two fill hoses, one drain
hose and four leveling legs. These can be
purchased from your Whirlpool Dealer (Kit
#3430190).
Portable one-faucet connection
Use the hose connector provided with the
washer for a one-faucet connection. Set the
Temperature Selector to WARM/WARM.
(See page 6 for portable two-faucet connec­
tion.)
To connect washer:
• Lift the hoses off the storage rack on the
back of the washer.
• Attach the hose connector to the faucet
adapter by pulling down on the locking
collar while lifting up on the connector
until it snaps into place.
• Slowly turn the water faucet on all the way.
• Pull the electrical power cord from the
storage area in the back of the washer.
Plug the power cord into a 3-prong
grounded outlet.
Water temperature ad|ustment:
Water Temperature Selector must be set to
WARM/WARM to ensure proper fills. Adjust
water temperature as follows;
• Wash Water: Adjust faucets for wash
water temperature prior to the fill for wash.
• Rinse Water: Adjust faucets for tempera­
ture prior to fill for rinse.
NOTE: Always use cold rinse water for
permanent press fabrics.