Using spin only, Manual clean lint filter – Whirlpool LCR5232DQ0 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

O P E R A T I N G Y O U R W A S H E R

Using Spin Only

The Spin Only cycle helps shorten drying
times for some heavy fabrics or special-care
items by removing excess water.

1. Turn the Cycle Selector Knob to Spin

Only, as illustrated.

2. Push the Start/Pause button. The washer

drains for 4 minutes and then proceeds to

spin. .

on both models

Manual clean lint filter

Clean filter after every load.
1. To remove, grasp the top of the agitator

with both hands. Pull upward to remove
agitator cap. Lint filter is attached to the
end of the shaft.

2. Detach lint filter by pinching forked ends

of shaft together. Slide lint filter off shaft.

3. Wash or wipe the lint filter clean.
4. Slide filter back into place on shaft (open

end up). Snap into place.

5. Push lint filter and agitator cap firmly back

into agitator.

Lint filter