Adiusunc the oven temperature control, Adiusunc, Temperature – Whirlpool FGS335E User Manual

Page 12: Oven, Control

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

USING YOUR RANCE

ADIUSUNC

the

oven

TEMPERATURE

control

Although your new oven is properly adjusted to
provide accurate temperatures, it may cook faster
or slower than your old oven.

If you are not satisfied with the baking/roasting

results, you can change the temperature calibration
by following the steps below.

NOTE: DO NOT measure the oven temperature with
a thermometer. Opening the oven door will lower the
oven temperature and give you an incorrect reading.
Also, the thermometer temperature reading will
change as your oven cycles.

1. Make sure the oven temperature control knob is

turned to the off position. Pull the knob straight
off and flip it over.

2. Loosen the locking screws inside the

control knob.

Note the position of the notches.

Notches

Locking
screws

3. Adjust the temperature.

• To lower the temperature, hold the knob

handle firmly and turn the skirt counterclock
wise to move the tooth a notch to the “E” on
the “COOLER” arrow.

• To raise the temperature, hold the knob

handle firmly and turn the skirt clockwise to
move the tooth a notch to the “E” on the
"HOTTER” arrow.

Each notch equals about 5°F.

To lower

Notches

To raise

Skirt

'Tooth

4. Tighten the locking screws and replace the

control knob.

Locking

screws