Whirlpool 3406449 - Manual (Page 11)

Recessed area and
closet installation
instructions
This dryer rriay be installed in a
recessed area or cioset.
The installation spacing is the
minimum allowable. Additional
spacing should be considered for
ease of installation, servicing and
compliance with local codes and
ordinances.
If closet door is installed, the minimum
unobstructed air openings in the top
and bottom are required. Door must
have two centered openings as
illustrated. Both openings must
provide a minimum of 72 square
inches of unobstructed airflow as
shown. Louvered doors with
equivalent air openings are
acceptable.
Companion appliance spacing
shouid be considered.
For cioset installation, to prevent iarge
amounts of iint and moisture from
accumuiating, to maintain drying
efficiency, and to prevent exposure to
possibie health hazards, dryers must
be exhausted outdoors.
Recessed non-exhausted installation
must use only the rear exhaust
position, and Exhaust Deflector Kit,
Part No. 3391278 (electric dryer only),
is required.
Shelf or cabinet is not permitted
above dryer when non-exhausted.
No other fuel-burning appiiance may
be installed in the same cioset.
Detailed space requirements for
recessed area and closet installations
can be found on the label on the
back panel of the dryer.
15"
0
"*_
Recessed
front view
Closet
door
.
0
"*
Side view
Product dimensions
Back view
. 3 - 3 / 8 "
* Additionoi clearances for wall, door
and floor moldings may be required or
if externai exhaust elbow is used.
■ Opening is minimum for cioset door.
Louvered door with equivalent air
opening is acceptable.
Page 11