Citizen Systems CBM-230/231 - Manual (Page 53)

CBM-230/231 User’s Manual
CITIZEN 53
(38) Data Input Control (ESC = n)
Code : [1B]h + [3D]h + n
* {0
≤
n
≤
FF} Data is described in Hex code.
Selecting equipment in which data input from the host is effective.
l Each bit of n indicates as follows:
VALUE B
IT
Device
0 1
0 Printer Invalid Valid
1 Undefined
2 Undefined
3 Undefined
4 Undefined
5 Undefined
6 Undefined
7 Undefined
l When the printer has not been selected, this printer abandons all received data until it
is selected by this command.
l Even when the printer has not been selected, it can become BUSY state through printer
operation.
l The initial value of n is "1".
(39) Aligning the characters (ESC a n)
Code : [1b]h + [61]h + n
* {0
≤
n
≤
2} Data is described in Hex code.
All the printed data within one line are aligned in the specified position.
l Depending on n value, positional alignment is carried out as in the table below:
n (Hex) POSITION
0 Left end alignment
1 Centering
2 Right end alignment
l This is valid only when n is inputted at the beginning of line.
l The initial value of n is "0".
(40) Full Cut (ESC i)
Code : [1B]h + [69]h
Full cutting of paper is performed.
l This is valid only when n is inputted at the beginning of line.
(41) Partial Cut (ESC m)
Code : [1B]h + [6D]h
Partial cutting of paper is carried out.
l This is valid only when n is inputted at the beginning of line.