Citizen Systems CBM-230/231 - Manual (Page 43)

CBM-230/231 User’s Manual
CITIZEN 43
(17) Selecting International Characters (ESC R n)
Code : [1B]h + [52]h + n
* {0
≤
n
≤
0A) Data is described in Hex code.
Selecting international characters.
l Depending on the value of n, following character sets are specified.
n(Hex) CHARACTER SET
0 U.S.A.
1 France
2 Germany
3 U.K.
4 Denmark 1
5 Sweden
6 Italy
7 Spain
8 Japan
9 Norway
A Denmark 2
l The initial value of n indicates the character set specified by the dip switch.
However, setting is available only through use of this command for "Spain ", "Norway", and "Denmark II".
(18) Setting of paper end detector available for output of paper end signal
Code : [1B]h + [63]h + [33]h + n
* {0
≤
n
≤
FF} Data is described in Hex code
Specifying the condition of paper end detector to stop printing operation.
l n is valid only for the lowest bit. (n0)
l n bit means the followings.
n0 Condition
0 Paper near end disable (initial value)
1 Paper near end enable
Remarks : This is valid only for parallel interface model.
(19) Setting of paper end detector available for print stop
Code : [1B]h + [63]h + [34]h + n
* {0
≤
n
≤
FF} Data is described in Hex code.
Specifying the condition of paper end detector to stop printing operation.
l n is valid only for the lowest bit. (n0)
l An initial value of “n” is specified by the Dip Switch (DS1-5).
l n bit means the followings.
n0 Condition
0 Paper near end disable (initial value)
1 Paper near end enable