Whirlpool 960 Series - Manual (Page 13)

S E T T I N G T H E C O N T R O L S
CYCLE
A shows what each cycle includes
WASHRINSE
MAIN
WASH RINSE
FINAL
RINSE DRY
CYCLE
TIME
(Minutes)
Heavy
Double wash for cleaning
heavily soiled loads.
• Select HIGH TEMP
WASH to heat water in
the main wash (marked^).
•The water heats to 140°F (60°C) in
the final rinse (marked unless you
select LOW ENERGY RINSE.
•t •n 76*
Pots-N-Pans
Double wash for maximum
cleaning of cooked-on or
baked-on foods.
• The water heats to 140°F
(60°C) in both washes
(marked ^).
• The water heats to 140°F (60°C) in
the final rinse (marked unless
you select LOW ENERGY RINSE.
•t •tt 76*
'Cycle time includes dry time and may be longer depending on the temperature of water entering the dishwasher.
The cooler the water, the longer the cycle time. If the water is already hot enough, the cycle times will be as shown.
Using CANCEL7DRAIN
Press CANCEL7DRAIN to cancel a cycle or
to clear the indicators.
To clear the indicators:
Press CANCEL/DRAIN before starting
the dishwasher to clear all cycle and option
selections.
To cancel a cycle:
• Press CANCEL/DRAIN while the dish­
washer is running to start a 2-minute
drain. It will take a few seconds for the
drain to start. If desired, select a new
cycle. (See “Changing a cycle or an
option setting” on page 14.)
• You can press CANCEL/DRAIN again to
stop the drain immediately. Remember to
drain the dishwasher again before starting
a new cycle.
NOTE: A small amount of water remaining
in the dishwasher is normal.
13