Whirlpool 830 - Manual (Page 7)

STARTING YOUR DISHWASHER
1. Load the dishwasher. See the “Loading
f.—
Your Dishwasher" section. a ■
2. Spin the spray arm. It should turn freely.
3. Add detergent. See the “Using the
Dispensers” section.
4. Add rinse agent, if needed.
5. Close door firmly until it latches.
6. Run hot water at the sink nearest the
dishwasher until water is hot.
Turn off water.
7. Select a drying option. (See the “Setting
the Controls" section.) For
models with buttons, the
indicator above the button
will show red when the option
has been selected. For
models with rocker switches, the switch
indicates which option has been selected.
NOTE; Select Air Dry for the Rinse &
Hold cycle. For Series 840
models, push a Cycle button
for the desired cycle. Normal
Wash, Light Wash, and Rinse
& Hold cycles share the same
button. The Cycle Control Knob deter­
mines which cycle operates. For Series
830 models, the Heat Dry option is
automatically selected with the Pots &
Pans cycle.
8 . Turn the Cycle Control Knob clockwise to
^ the desired cycle. You will
feel a definite “stop" at each
cycle mark. The dishwasher
automatically starts the cycle
you select.
NOTE: If the door is latched, you will hear
the cycles start and stop as the control
knob passes each cycle mark. This is
normal and does not hurt the dishwasher.
If you prefer, you can set the Cycle
Control Knob with the door unlatched.
Stopping the dishwasher
You can stop your dishwasher anytime
during a cycle. All you have to do is:
• Open the door slightly. Wait for any filling
or spraying action to stop before opening
the door all the way. Close the door to
continue the cycle.
OR
' Turn the Cycle Control Knob slowly
clockwise until you hear water draining.
Let the dishwasher drain completely. Then
open the door and turn the Cycle Control
Knob to Off.