Whirlpool 830 - Manual (Page 28)

Troubleshooting
Before calling for assistance please check the chart below for problems you can fix. It
could save you the cost of a service call.
Dishwasher problems
PROBLEM CHECK THE FOLLOWING
Dishwasher does
not run or stops
during a cycle Is the door tightly closed and securely latched?
Has the cycle been set correctly? See the “Setting the Controls”
section.
Has a household fuse blown or circuit breaker tripped?
If the motor stopped because of an overload, it will automatically
reset itself within a few minutes. If it does not start, call for service.
Is the water supply turned on?
Dishwasher Is the overfill protector stuck in “up” position? Overfill protector
will not fill should move up and down freely. Press down to release. See the
“Caring for Your Dishwasher” section.
Water remains
in dishwasher
Allow cycle to finish. A small amount of water remaining is normal.
Check the drain air gap (if installed). If It is clogged, follow the
manufacturer's cleaning instructions.
Detergent remains
in covered section Has the cycle completed?
of dispenser
Is the detergent fresh and dry without lumps? See the “Using the
Dispensers” section.
Is the bottom rack in backwards? The rack bumpers must face the
dishwasher door.
Dishes not as dry Is the rinse agent dispenser empty? Using a rinse agent greatly
as you expected improves drying. See the “Using the Dispensers” section.
Do not use Air Dry option on the next load. See the “Setting the
Controls” section.
White residue Is too much detergent being used? See the “Using the Dispensers”
appears on front section.
of access panei
Some liquid detergents develop excess foam and residue on panel.
Try a different brand to reduce foaming and eliminate buildup.
Dishwasher wiii Is the bottom rack in backwards? The rack bumpers must face the
not close dishwasher door.
28