beautypg.com

Changing a cycle setting, On some models), Adding an item during a cycle – Whirlpool 830 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

SETTING THE CONTROLS

Changing a cycle setting

(on some models)

You can change a cycle setting anytime
during any cycle.

1. Lift up the door latch to stop the cycle.

2. Turn the Cycle Control Knob clockwise to

the desired cycle.

3. Check the detergent dispensers. They

must be filled properly for the new cycle.

NOTE:

Turning the Cycle Control Knob

can cause the covered section of the
detergent dispenser to open and release
the detergent. Check the covered
section if setting Normal Wash or Pots &

Pans cycle.

4. Close the door firmly until it latches. The

dishwasher starts the new cycle.

Adding an item during a cycle

(on some models)

You can add an item to the dishwasher
anytime before the Cycle Control Knob

reaches Light Wash. Items added after the
Cycle Control Knob reaches Light Wash will
only be rinsed.

1. Lift up the door latch to stop the cycle.

Wait for spraying action to stop before
opening the door.

2. Open the door and add the item.

3.

Close the door, but do not latch it. Wait

30 seconds for the air in the dishwasher

to warm up. Doing so reduces the amount

of moisture in the vent when restarting
a cycle.

4. Close the door firmly until it latches. The

dishwasher resumes the cycle.

15