Whirlpool 8900 - Manual (Page 8)

U S I N G Y O U R D I S H W A S H E R
Changing a cycle setting
You can change a setting anytime during any cycle
1. Lift up on the door latch to unlatch the
door and stop the cycle.
2. Turn the Cycle Control knob clockwise to
the cycle you want.
3. Push the desired Cycle Selection button.
4. Check the detergent dispenser to be sure
it is properly filled for the new cycle. See
page 12.
5.
NOTE: Turning the Cycle Control knob
may cause the covered section of the
detergent dispenser to open. Be sure to
fill the covered section if the cycle uses
detergent in both sections.
Close and latch the door. The dishwasher
will automatically start the new cycle.
Changing an option
You can change an option anytime during a
cycle. To change the selected option(s):
1. Push the RESET OPTIONS button.
2. Push an Option Selector button for each
desired option.
RESET
OPTIONS
□
Canceling a cycle
You can cancel a cycle anytime during the cycle.
1. Turn the Cycle Control knob slowly
clockwise to the drain portion of the wash
or rinse. You will hear water draining
when you have advanced to the proper
location.
2. Let the dishwasher drain completely.
3. Lift up on the door latch to unlatch the
door.
4. Turn the Cycle Control knob clockwise to
point to OFF.
Cycle selection chart
Cycle
A shows what steps are in each cycle
Wash Rinse
Main
Wash Rinse Rinse Dry
Cycie
Time
(Minutes)
Pots & Pans
A double wash for
maximum cleaning
of cooked-on or
baked-on foods.
NOTE: The Cycle Control knob
stops while the dishwasher heats
water to 135°F (57°C) in both
washes and the final rinse
(marked t)- See page 10.
90-120*