Whirlpool 8900 - Manual (Page 11)

U S I N G Y O U R D I S H W A S H E R
Hi-Temp Wash option
If the Hi-Temp Wash option is selected,
water is heated in the dishwasher during the
main wash of the Heavy Wash, Normal
Wash, Light Wash and China Crystal cycles
to improve washability. The Hi-Temp Wash
option is automatically selected for the Pots
& Pans cycle. See “Cycle selection chart" on
pages 8-10.
Lo-Energy Rinse option
If the Lo-Energy Rinse option is selected,
water is not heated in the dishwasher during
the final rinse of the Heavy Wash, Normal
Wash, Light Wash and China Crystal cycles.
The Lo-Energy Rinse option cannot be
selected with the Pots & Pans cycle. See
“Cycle selection charf on pages 8-10.
NOTE:This option will reduce the amount of
electricity used to run the dishwasher, but
may result in slower drying and some
spotting on dishes. For best drying and
rinsing resuits, use a liquid rinse agent.
Air Dry option
If the Air Dry option is selected, air in the
dishwasher is not heated during the “dry”
part of the cycle. Using this option helps
save energy, but dishes take longer to dry
(overnight) and some water spotting may
result. Some items (such as plastics) may
need towel drying. For best drying results,
use a liquid rinse agent.
SELECT
WASH
□
SELECT
LO-ENERGY
RINSE
□
SELECT
DRY
□
The signal lights
Delay signal light
The DELAY signal light will glow when a
delay start time has been set. It will also
glow while the dishwasher has paused to
heat water (see above).
Water heating signal light
The WATER HEATiNG signal light will glow
while the dishwasher is heating water for a
cycle. See cycle selection chart on pages
8
-
10
.
Clean signal light
The CLEAN signal light will glow when a
washing cycle is complete. To turn it off, turn
the Cycle Control knob clockwise slightly
until the light goes off.
DELAY
WATER
HEATING
CLEAN