Whirlpool DRYERS - Manual (Page 8)

O P E R A T I N G Y O U R D R Y E R
Using the automatic cycles
Your DRY-MISER* control senses the dryness
of the load and automatically shuts off when the
selected dryness is reached. For the first few
loads:
1. Set the Cycle Control Knob to point to the
center mark in your automatic cycle.
2. Select a heat setting to match your load.
3. Push the Start Button. The Cycle Control
Knob will not move until the load is almost
dry or the cool-down portion of the cycle
has been reached. After the cool down is
compiete, the Cycle Control Knob automati­
cally moves to an OFF area and the
tumbling stops.
Cycle control knob
with temperaturee
built-in
Models with a tempera­
ture selector
Feel the dried items when the dryer stops.
It the Items are drier than you like, select a
setting closer to LESS DRY the next time you
dry a similar load.
If Items are not as dry as you like, select a
setting closer to VERY DRY the next time you
dry a similar load.
Cycia control knob
with temperatures
built-in
Models with a tempera­
ture selector
Automatic DRY-MISER control
(on some models)
The automatic DRY-MISER control uses a
thermostat that senses the dryer's air tempera­
ture. The dryer automatically shuts off when
the selected dryness is reached.
Electronic DRY-MISER control
(on some models)
The electronic DRY-MISER control uses an
electronic sensor that determines the amount
of moisture in the clothes. The dryer automati­
cally shuts off when the selected dryness is
reached.