Whirlpool DRYERS - Manual (Page 6)

O P E R A T I N G Y O U R D R Y E R
Operating Your Dryer
In This Section
Page Page
Before starting your dryer......... ........... 6 Selecting a cycle................. .................. 7
Starting or stopping your dryer. ........... 6 Using the drying rack.........
To obtain the best drying resuits, you must operate your dryer properly. This section gives you
important information for efficient and safe use of your dryer.
Before starting your dryer
If your dryer has a Consumer Buy Guide,
remove it and place it in your Use and Care
Guide. Refer to the information below, and “Laundry
Tips” for control setting, sorting, and loading
information.
Starting or stopping your dryer
Starting your dryer
Close the door and select a cycle and tem­
perature. See pages 7-16 for additional setting
information. Your dryer automatically stops
when a cycle ends.
Stopping and restarting your
dryer
Open the dryer door or turn the Cycle Control
Knob to OFF. Close the door; make new
selections (if necessary). Push the Start
Button.
NOTE: The Cycle Control Knob should point to
an OFF area when the dryer is not in use. If
the dryer is stopped before the cycle is
finished, turn the Cycle Control Knob to an
OFF area.
End of cycle signal
(on some models)
The dryer sounds a signal to let you know
when the cycle is finished. The signal Is not
adjustable, but can be turned off (on some
models). If your model has an End of Cycle
signal selector, see page 11.
The signal is helpful when you are drying
permanent press, synthetics and other items that
should be taken out as soon as the dryer stops.
4