Whirlpool DRYERS - Manual (Page 25)

L A U N D R Y T I P S
Curtains,
slipcovers
• Draperies,
slipcovers
• Sheers, some
synthetic curtains
• Bonded or
laminated fabrics
Remove drapery weights and hooks before laundering.
1. Use lowest temperature or an Air setting.
2. Leave room in dryer for load to fluff.
3. Remove from dryer while slightly damp. Do not overdry.
For slipcovers, replace slipcovers while still slightly damp. They will dry to
fit tightly.
Dry only a few minutes.
Do not overdry or tumble in high heat. Overdrying loosens the adhesive
and causes fabrics to separate.
Diapers, baby
clothes
Wash and dry small items in a mesh bag or pillowcase for convenient
handling.
1. Dry according to fabric and cycle settings listed on your control panel
page (pages 12-16).
2. Remove diapers and cotton knit items while still slightly damp. They
will feel softer, shrink less and be easier to fold.
Elastic Kerns Dry at lowest temperature setting. Remove from dryer while still slightly
damp.
Fiberglass
materials
Do not machine wash or dry fiberglass materials. Small particles can stick
to fabrics washed or dried in following loads and cause skin irritation.
Flame-
retardant
finishes
Some items have been treated with a flame-retardant finish to improve
their resistance to burning. Such items are clearly labeled. To retain
flame-retardant qualities through continuous use and washing, clean and
dry according to the manufacturer’s instructions.
Napped
Items Dry separately or with similar colors to avoid lint transfer. Follow care
label directions.
1. Dry according to fabric and cycle settings shown on your control panel
page (pages 12-16).
2. Remove from dryer while there is still a trace of moisture.
3. Smooth, reshape and air dry before putting away.
• Corduroy,
velveteen
Quilted, down-
filled Items
Follow care label instructions.
1. Dry one at a time.
2. Remove from dryer and shake or fluff the item during the drying cycle.
3. Smooth and reshape before putting away.
Snowsults,
Jackets
• Nylon,
polyester-base
Check label for fiber content, then see your control panel page
(pages 12-16) for cycle and temperature recommendations.
Follow care label directions.
1. Dry garment for about 10 minutes. Remove and turn inside out. Dry for
10 more minutes.
2. Remove from dryer immediately and hang on a non-rusting hanger to
finish drying. This will help eliminate wrinides.
continued on next page
25