Using your dishwasher, In this section, Before starting your dishwasher – Whirlpool DISHWASHERS User Manual
Page 6: Starting your dishwasher
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

U S I N G Y O U R D I S H W A S H E R
Using Your Dishwasher
In This Section
Page
Before starting your dishwasher.......... 6
Starting your dishwasher..................... 6
Starting your dishwasher using
delay wash............................................. 7
The clean signal light............................7
Adding a dish during a cycle............... 8
Changing a cycle setting......................8
Changing an option.............................. 8
Canceling a cycle.................................. 8
Page
Cycle selection chart............................ 9
What happens in each option............ 10
Using the detergent dispenser..........11
Using the rinse agent dispenser....... 12
Quiet operating tips............................ 13
Water temperature tips....................... 14
Energy saving tips.............................. 14
Special tips on dishwasher use........ 15
Operating your dishwasher properly enables you to obtain the best possible results. This
section explains proper dishwasher operation.
Before starting your dishwasher
1. Properly load the top rack, bot
tom rack, and the silverware bas
ket. See pages 16-19.
2. Spin both spray arms with both
racks in place to make sure noth
ing prevents arms from turning
freely.
3. Add detergent. See pages
11 and 12.
4. Checktherinseagentdispenser.
See pages 12 and 13.
5. Push door firmly when closing
and it will automatically latch.
6. Run hot water at sink nearest
dishwasher until water is hot.
Turn off water.
POTS & UCAirV
PANS ^^EAVY
Starting your dishwasher
The dishwasher will wash and dry dishware according to the selections you make on the
control panel.
1. Push a Cycle Selector button for the desired
cycle. The indicator above the button will
show red for the selected cycle.
NOTE: Normal Wash and Light Wash
cycles share the same button. The Cycle
Control knob determines which cycle
operates.
2. Push an Option Selector button for each
desired option. The indicator above the
button will show red for the selected option.
□□□□
a
d
a
HhTEMP
AIR
RESET
WASH
DRY
OPTIONS