Connecting a portable dishwasher, Before starting, While dishwasher is running – Whirlpool DISHWASHERS User Manual

Page 20

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

C O N N E C T I N G A P O R T A B L E D I S H W A S H E R

Connecting A Portable

Dishwasher

NOTE: A special adapter must be installed on the
faucet before the dishwasher can be connected.
Complete instructions and the adapter are
packed with your dishwasher.

When moving your dishwasher make sure the

door is latched. Hold the dishwasher at the top

front comers.

Before starting

1. Run water at faucet until it is hot. Turn water

off.

2. Pull hoses out of their storage compartment on

the back of the dishwasher.

NOTE: Make sure the hoses are not
kinked or twisted. Kinked hoses reduce
washing performance.

Hose pull ring

3. Pull down on the locking collar while lifting the

hose connector onto the faucet adapter.

4. When the connector snaps into place, release

the locking collar.

5. Turn the hot water on slowly until it is all the

way on.

6. Plug in power supply cord.

7. See page 6 for instructions on how to

start the dishwasher.

Locking collar

Hose connection

While dishwasher is running

You can draw water from the faucet while the
dishwasher is connected. Do not draw water
while the dishwasher is filling or while water is
being pumped out. (This helps prevent a low fill
when dishwasher is filling or mixing drain water
with fresh water.)

• Press the red button on the hose con

nector to draw water from faucet. (The

faucet is set on hot. Adjust faucet for the

water temperature you want.)

NOTE: Turn hot water back on after you

draw water from faucet. Turn off cold

water.