Whirlpool DISHWASHERS - Manual (Page 21)

C O N N E C T I N G A P O R T A B L E D I S H W A S H E R
When cycle is finished
1. Turn hot water off. (This can be done after the
last rinse.)
2. Press the red button on the connector to
release the water pressure.
3. Lift slightly on the hose connector while pulling
down the locking collar. Pull down on the
connector.
4. Empty any remaining water from the
connector by turning the connector
upside-down.
5. Unplug power supply cord and return to
storage compartment.
6. Return hoses to storage compartment.
Locking collar
Hose connection
Electrical connection
A power supply of 120 volts, 60Hz AC, 15 or 20
amps, is required. For your personal safety, this
appliance must be grounded. This appliance is
equipped with a power supply cord having a
3-prong grounding plug. To minimize possible
shock hazard it must be plugged into a mating
3-prong grounding type wall receptacle,
grounded in accordance with the National
Electrical Code and local codes and ordinances.
If a mating wall receptacle is not available, it is
the responsibility and obligation of the customer
to have a properly grounded 3-prong wall
receptacle installed by a qualified electrician.
A
warning
Personal Injury Hazard
An extension cord should not be used
with this appliance.
Such use may result in a fire, electrical
shock or other personal injury.
Do not, under any circumstances,
remove the power supply cord ground
prong.
3-prong
grounding
cord
3-prong
grounding
type wall
receptacle
Converting to built-in
Your Whirlpool Portable Dishwasher can be
converted to a built-in (undercounter) model by
using conversion kit No. 4317856. The kit is
available at your Whirlpool dealer or authorized
Whirlpool®“ service company. Instructions are
included with the kit. 21