Solving laundering problems – Whirlpool LLC7244BQ0 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

L A U N D R Y T I P S
Solving laundering problems
Most laundering problems are easily solved if you undtirstand the cause. Check the following
list for problems you may have and possible causes. If you need additional help, check the
“Assistance or Service” section of this book.
PROBLEM
CAUSE
Brown, yellow
stains
•
Chlorine staining
•
Iron in water heater or pipes
•
Iron and manganese in water
Dye transfer
•
Improper sorting
•
Load not immediately removí d from washer after end of cycle
Gray whKes,
dingy colors
•
Improper sorting
•
Water temperature too low
•
Not enough detergent
•
Using soap in very hard wate- (use detergent if you have hard water)
Greasy looking
spots
•
Undiluted fabric softener or f£ brie softener poured directly on load
• Fabric softener in wash watei
• Not enough detergent
Lint
• Improper sorting
• Paper or tissue in pockets
• Pilling being mistaken for lint
• Overloading
• Not enough detergent
Load too wet
after spin
• Cold rinses
•
Lid is opened before spinning is completed
Shrinking
•
Fabric type (some knits stretch during manufacturing-laundering returns
fabric to original size)
•
Care label directions not followed
Snags, rips, holes
•
Items damaged before washing
•
Misuse of chlorine bleach
•
Sharp articles not removed from pockets
•
Overloading
•
Fasteners not fastened
Stiff, rough fabrics
(usually cottons)
•
Using soap in very hard watei (use detergent if you have hard water)
•
Not enough detergent
•
Line drying
Twisting, tangling
•
Overloading
•
Improper loading (do not wrap large items around agitator)
Wrinkling
•
Overloading
•
Load not immediately removed from washer after end of cycle
•
Improper rinse temperature
•
Cycle selection is incorrect (be sed on fabric type)
Yellow areas
(from body oils)
•
Water temperature too low
•
Not enough detergent
22