What happens in each cycle – Whirlpool LLC7244BQ0 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

P E R A T I N G Y O U R W A S H E R
What happens in each cycle
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to the
selected load size) before agitation and timing
start. The washer will begin agitating immedi
ately after filling; agitation can occur with the
washer lid up or down. After agitation starts,
the Cycle Control Knob turns clockwise until it
points to OFF and the cycle ends.
WASH
Thi) washer pauses briefly throughout each
eye le.
These pauses are normal for washer
op£ ration.
NOTE:
A Gentle Wash system helps protect
yoLr fabrics (if high-speed agitation is selected)
by reducing wash agitation speed during the
last few minutes of wash agitation in the Heavy,
Rei|ular and Permanent Press cycles.
RINSE
Fill
ira I
M
Wash selected time*
H high-speed agitation Is selected, agitation speed Is
reduced In the last lew minutes of most cycles. This
provides better fabric care.
Drain (or partial drain*)
No agitation
* The Permanent Press cycle partially drains, tills.
agitates briefly, and drains.
Spin
......
Fill
Rinse
Drain-No agitation
^1^ 1 Spin-Spray rinse
Spin
12} ^
11