Whirlpool 9200 SERIES - Manual (Page 7)

WATER HEATING
The WATER HEATING signal light
The WATER HEATING signal light comes on
during the water heating portions of the Pots &
Pans Cycle. The signal light will also come on
during the water heating portion of other cycles
when the Hi-Temp Option is selected.
The WATER HEATING signal light will flash at
the end of the cycle if the water did not heat to
140°F (60°C). If you want to make sure the water
gets heated to 140°F (60°C), use the Hi-Temp
Option (see page 10).
When the signal light is on, water is being
heated. The heating time is based on the tempera­
ture of the water supply as it enters the dish­
washer. The cooler the water, the longer the
heating time. The WATER HEATING signal light
will go off when the water temperature reaches
140°F (60°C).
CLEAN
The CLEAN signal light
The CLEAN signal light comes on at the end of a
cycle to show that the load is clean. It will stay on
until CANCEL/DRAIN or any other control pad is
pressed.
As an option, you can have the CLEAN light turn
off the first time you open the door after a cycle
is finished:
1. Press and hold the CYCLE pad until the
CLEAN signal light starts flashing.
2. Release the pad. The CLEAN signal light will
turn off.
NOTE: A power failure will reset this feature. You
will have to redo the above steps.
D
CLEAN
To again have the signal light stay on when the
door is opened:
1. Press and hold the CYCLE pad until the CLEAN
signal light turns on.
2. Release the pad. The CLEAN signal light will
turn off.