Control panel lock-out feature, To use the lock-out feature, To cancel the lock-out feature – Whirlpool 9200 SERIES User Manual
Page 6: The beeping sound, To turn off the beep, To turn the beep back on, Control panel lock-out feature the beeping sound
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Operating Instructions
Continued
Control panel lock-out feature
This feature lets you lock-out the function of the
control pads (except to cancel or pause a cycle
that is running). When the control panel is locked-
out, the dishwasher cannot be started and a
running cycle cannot be changed.
CLEAN
To use the lock-out feature:
1. Press and hold the OPTIONS and DELAY pad
until the CLEAN signal light flashes.
2. Release the pads. The CLEAN signal light will
stop flashing.
To cancel the lock-out feature:
1. Press and hold the OPTIONS and DELAY
pad until the CLEAN signal light turns on and
stays on.
2. Release the pad. The CLEAN signal light will
turn off.
The beeping sound
Each time a control pad is pressed, a single
“beep" sound is made. A double beep means one
of the extra features was selected (such as control
panel lock-out) or the wrong control pad was used.
To turn off the beep:
1. Press and hold the OPTIONS pad until the
CLEAN signal light flashes.
2. Release the pad. The CLEAN signal light will
turn off.
NOTE: A power failure will reset this feature.
You will have to redo the above steps.
CLEAN
To turn the beep back on:
1. Press and hold the OPTIONS pad until the
CLEAN signal light turns on and stays on.
2. Release the pad. The CLEAN signal light will
turn off.