Whirlpool 9200 SERIES - Manual (Page 4)

Operating Instructions
Continued
Control pads
■Signal lights
Starting your dishwasher
1. Press the START pad once to display the cycle
and options. Skip to Step 4 if you want to run the
cycle and options shown by the lights.
2. Press the CYCLE pad until the cycle you want
is indicated by a signal light, Each press of the
CYCLE pad advances the signal light to the
next cycle.
3. Press the OPTIONS pad until the option you
want is indicated by a signal light. Each press of
the OPTIONS pad advances the signal light to
the next option.
4. Press the START pad again.
NOTE: Cycle and option selections are cancelled
by a power failure.
Changing a cycle setting
You can change a setting anytime during
any cycle.
1. Press the CANCEL/DRAIN pad. The dish­
washer will go into a 2-minute drain cycle, if
needed.
2. Select a new cycle and option.
3. Be sure the detergent dispensers are filled
properly for the new cycle.
4. Press the START pad. The dishwasher will start
the new cycle.