Whirlpool FGS395Y - Manual (Page 23)

U S I N G T H E S E L F - C L E A N I N G C Y C L E
Using The Self-Cleaning
Cycle
In This Section
Page Page
How the cycle works...................... .................. 23 Setting the controls................. ..................... 24
Before you start............................. .................. 23 Special tips............................... ......................26
The Self-Cleaning cycle saves you from the toil and mess that often come with hand-cleaning the oven
interior. Like with the other functions of your range, you operate the Self-Cleaning cycle with the easy-
to-use control. Please review the instructions in this section to keep your oven spotless.
How the cycle works
The Self-Cleaning cycle uses very high heat to
burn away soil and grease. During the cycle, the
oven gets much hotter than it does for normal
baking or broiling. This high heat breaks up the
soil or grease and burns it away.
We recommend a 3-hour Self-Cleaning cycle.
However, you can adjust the cycle time to the
amount of soil in your oven. You can set the cycle
anywhere between 2 and 4 hours. (See “Setting
the controls” on page 24.)
The graph at the right is representative of a
normal, 3-hour Self-Cleaning cycle. Note that
the heating stops when the 3-hour setting is up,
but it takes longer for the oven to cool enough
to unlock.
Time In Hours
Before you start
Before you start the Self-Cleaning cycle, make
sure you;
• Hand-clean the areas shown. These areas do
not get hot enough during the cleaning cycle for
soil to burn away. Use hot water and detergent
or a soapy steel-wool pad for cleaning.
NOTE: DO NOT clean, move or bend the seal.
Poor cleaning, baking and roasting may result.
23