Carl Goldberg GBGA1043 - Manual (Page 12)

12
2. Epoxy the rear bulkhead in place with the
notch on the bottom fitting over the receiver tray
and flush against the bulkhead.
3. Epoxy the servo tray to the rear bulkhead
making sure the servo cutout is to the rear of the
wing tube.
4. Epoxy the front bulkhead in place sitting on
the cockpit floor and back against the bulkhead.
5. If you are using a large motor you may want
to install a piece of tri-stock (not included) along
the front side of the servo tray and the bottom of
the wing tube. This will add strength to the servo
tray.
Rudder Servo
1. * Collect the following parts:
(2) braided steel cable
(2) metal clevis
(2) 4-40 nuts
(2) clevis retainers
(4) threaded cable couplers
(4) cable swages
2. Mount the rudder servo in the tray supplied just
behind the wing tube.