Carl Goldberg GBGA1084 - Manual (Page 19)

19
Wild Stick 120
9. Locate the pull-pull cable, cable
ends and cable swages. Take two of
the rigging couplers and two of the
swages and insert the cable through
the swage, through the rigging cou-
pler and loop back through the
swage. Crimp the swage in two places
on opposite sides to secure the cable
in place.
swage
rigging coupler
10. Install a nut and clevis with sili-
cone keeper on the rigging coupler
and attach to rudder horn. Thread
the other end of the cable through
the slot in the fuse and pull forward
to the rudder servo. Repeat on the
other side.
11. Take the other two rigging cou-
plers and install the nut and clevis.
Attach to the rudder arm and install
the silicone keeper. Tape the rudder
in place with it centered and center
the servo. Thread the pull-pull cable
through the swages and rigging cou-
plers on both sides. Pull both cables
tight, get as much slack as possible
out now. When tight crimp both
swages.