Carl Goldberg GBGA1084 - Manual (Page 10)

10
Wild Stick 120
11. Epoxy the fin in place making sure
it is square to the stab and centered
on the fuselage in the rear.
Flying Wires
Locate the following parts:
Aluminum bracket for fuse bottom 1
2mmx10mm screws
2
angle brackets 12
1.8x16mm bolts 6
1.8mm nuts
6
flat washers 12
nylon swing in keepers 8
2mm pushrods with clevis x 10” 4
2mm pushrods with clevis x 7” 4
silicone clevis keepers
8
1.Take four of the angle brackets, two
screws, two nuts and four flat wash-
ers and bolt to the top of the fin in
the predrilled holes. You will have to
locate the holes under the covering.
Put two brackets on each side of the
fin.
2.Repeat with the other brackets on
the end of the stab. Put brackets on
both sides top and bottom.