Carl Goldberg GBGA1077 - Manual (Page 2)

2
ITEMS NEEDED TO COMPLETE THIS AIR-
CRAFT
1 RADIO GUIDANCE SYSTEM (5 CHAN-
NEL MINIMUM REQUIRED) 8 SERVOS
2 6” FLAP SERVO EXTENSION WIRES
2 18” AILERON SERVO EXTENSION
WIRES
2 Y-HARNESS
1 ENGINE .90-.1.20 2-CYCLE or .90-1.80 4-
cycle, AND MUFFLER
1 CA Accelerator
1 2 OZ. Bottle medium CA
1 1/2 OZ. Bottle Thin CA
1 30 minute and/or 5 minute epoxy.
1 Foam rubber 1/2”x8”x12”
1 3” Spinner
TOOLS AND SUPPLIES FOR ASSEMBLY .
MODELING OR UTILITY KNIFE
WORK SURFACE (24" X70")
ELECTRIC DRILL
1/16”,5/64” 3/32”,1/8", 5/32”, 1/4” DRILL
BITS
SMALL STANDARD & PHILLIPS SCREW-
DRIVERS
MASKING TAPE
NEEDLE NOSE PLIERS
36” RULER OR TAPE MEASURE
FLEXIBLE STRAIGHT-EDGE
T-SQUARE
30-60-90° x 6" TRIANGLE
SOFT PENCIL
A FEW STRAIGHT OR "T" PINS
ADJUSTABLE WRENCH
WIRE CUTTER
OPTIONAL HEAT GUN/COVERING IRON
ACID BRUSH
NOTE: The Tiger 120 ARF is covered in White
(#870) UltraCote®. The trim colors are
True Red #866, Yellow #872 and Orange
#877.