Carl Goldberg GPMA1967 Sr. Falcon ARF - Manual (Page 9)

9
7.
Remove the covering inside the line you drew
on the stab also.
5.
Epoxy the fin to the stab making sure it is
perpendicular.
6.
Place the stab on the fuselage with the fin in
the notch on top and center the stab at the
rear of the fuselage. Mark the bottom of the
stab next to the fuselage.
10.
Check the alignment of the stab-fin with the
wing and make sure it is parallel. Use mask-
ing tape to hold the structure in place till the
epoxy set.
8.
Remove the covering on the stab saddle of
the fuselage so the stab will glue to bare
wood.
9.
Bolt the wing in place and epoxy the stab-fin
structure to the fuselage.
Remove covewring
11.
Install the rudder using the CA hinges and
mark the location on the rudder horn in line
with the slot on the right side of the fuselage.
Do not glue yet.