Carl Goldberg GPMA1967 Sr. Falcon ARF - Manual (Page 13)

4. Mark the location of the engine mounting
holes.
Also at this time mark the location of where
the throttle pushrod should exit the firewall.
Remove the engine and the motor mount
plate.
5. Drill the engine mounting holes in the plate.
6. Drill the hole for the engine throttle pushrod.
7. Install the motor on the plate using the 4mm
blind nuts and bolts.
8. Remove the motor and put the motor plate in
the opening and mark the location of the blind
nuts.
9. Mark the area of the beams that will be under
the blind nuts and remove enough material to
allow the plate to sit flush on the beams.
13