Carl Goldberg GPMA1967 Sr. Falcon ARF - Manual (Page 8)

Mark wire
STAB & ELEVATOR INSTALLATION
1. Collect the following parts:
(1) Stabilizer
(2) Elevator
(1) Wing/fuse assembly
(6) Jet hinges
(1) Fin and Rudder
2. Insert the fin in the slot in the top of the stab.
3. Use a marker and draw a line around the
base of the fin where it enters the stab.
4.
Using the mark as a guide, remove the cover-
ing inside the line. Use a sharp knife or razor
blade and cut about 1/8” inside the line so no
bare wood will show.
6. Make sure the aileron is in neutral (level)
position, mark where the wire meets the hole
on the servo arm.
Remove the wire and cut it about 1/2"
beyond the mark.
7. Bend the wire 90 degrees up at the mark you
just made.
Slide the swivel keeper over the wire and clip
onto the pushrod.
Slide the silicone keeper over the clevis.
Repeat these steps for the other aileron servo.
8