Carl Goldberg GBGQ1296 - Manual (Page 2)

2
ITEMS NEEDED FOR INSTALLATION ON MOD-
ELS OTHER THAN CGP CUB
2 24” LENGTHS OF 5/32” WIRE (FOR NEW
STRUTS)
2 CG 5/32 LANDING GEAR CLAMPS
NOTE: The Superfloats ARF covering matches:
Silver (Oracover)
TOOLS AND SUPPLIES FOR ASSEMBLY.
MODELING OR UTILITY KNIFE
WORK SURFACE (24" X70")
ELECTRIC DRILL
1/16”, 3/32”,1/8", 3/16”, 5/32”, 1/4”, 5/64”
7/32” DRILL BITS
SMALL STANDARD & PHILLIPS SCREW-
DRIVERS
MASKING TAPE
NEEDLE NOSE PLIERS
MOTO TOOL
24” RULER
FLEXIBLE STRAIGHT-EDGE
LEVEL
SOFT PENCIL
WIRE CUTTER (DYKES)
OPTIONAL HEAT GUN/COVERING IRON
ACID BRUSH
ELECTRICAL TAPE
SOLDERING IRON, FLUX, SOLDER
PIECE OF MEDIUM SANDPAPER
Welcome to the exciting world of
flying off water. The CGP Superfloats
ARF were designed specifically for the
CGP Cub either the Kit version or the
Almost-Ready-to-Fly version, yet will
work very well with almost any plane in
the 6 to 9 lb., .50 to .90 engine range.
Please follow the instructions carefully.
We also recommend the ventral fin,
because as in the full-size seaplanes it
can help directional stability, making the
model even easier to fly.