CAMCORP CAM-AIRO Vertical Cartridge - Manual (Page 20)

CAMCORP, INC.
Phone: 913-831-0740 Fax: 913-831-9271
www.camcorpinc.com
10 !, ) 65.
Installation
Make sure the unit is secured to the floor or mounting surface. The
ladder(s) and platform(s) must be tightened and set up according to
OSHA requirements. Ducting and piping must be secured and routed out
of the way of traffic whenever possible to avoid injury. Ducting must also
be free of all debris including moisture.
Interior of Dirty Air Plenum
Inspect the filter cartridges, referring to the “Filter Cartridge Installation”
section of this manual. Improperly installed cartridges may allow dusty air
to enter the clean air plenum.
Exterior of Dust Collector
Access doors, inspection ports and spring-loaded relief vents should seat
effectively to prevent leakage.
All bolts must be properly tightened.
Operate any equipment connected to the dust discharge of the dust
collector. Check the rotation of any motor driven equipment such as
rotary airlocks, horizontal unloading valves, live bottom bin activators and
screw conveyors. Check slide gates and butterfly valves for binding .
4-2