C&D Technologies RS-1826 Liberty Series 1000 FA Battery - Manual (Page 4)

WARNING
This battery is designed for industrial use only and is not
intended for application in vehicular starting, lighting, and
ignition and/or operation of portable tools and appliances. The bat-
tery should be used only in accordance with manufacturer’s writ-
ten instructions. Use of this product other than in accordance with
manufacturer's written instructions may produce hazardous and
unsafe operating conditions, leading to damage of equipment
and/or personal injury.
The battery should be charged only in accordance with manu-
facturer’s operating instructions. Do not expose the battery to
open flame or electrical arc. Do not tamper with cell cover or
vents. VRLA batteries contain sulfuric acid, which can cause
severe burns. Mishandling or abuse could cause the battery’s
case to rupture. In case of skin contact with electrolyte, remove
contaminated clothing and flush affected areas thoroughly with
water. If eye contact has occurred, flush one eye thoroughly for
15 minutes with running water and seek immediate medical
attention.
Recommended Tools for Installation and Maintenance
The following list of tools is a general recommendation and is not
intended to be a complete list. Each installation may require special
tools which can not be specified without specific knowledge of the
installation.
Safety
1. Rubber or Neoprene - Acid resistant gloves.
2. Protective apron
3. Face Shield or goggles (ANSI approved).
4. Rubber soled safety shoes/boots.
5. Insulated tools.
6. Portable eye wash for rinsing of eyes in case of contact with
electrolyte.
Installation
1. Lifting sling or platform (dependent on battery size and
weight).
2. Insulated tools.
3. Torque wrench.
4. Digital voltmeter (three digit accuracy).
5. Resistance, conductance or impedance meter. (Select one
method)
6. Non-metallic brush or pad for cleaning connections.
7. No-Ox-Id grease and brush.
2