0 safety – Boekel Scientific 281111-2 Orbitron V User Manual
Page 4

4
1.0 Safety
The following symbol marked on the equipment means:
Caution: Read these operating instructions fully before use and pay
particular attention to sections containing this symbol.
Attention: Suivre attentivement les instructions avant l’usage et
prêtez une attention particulière aux sections comportant ce
symbole.
Always observe the following safety precautions :
•
Use only as specified by the operating instructions or the intrinsic
protection may be impaired.
•
After transport or storage in humid conditions, dry out the unit
before connecting it to the supply voltage. During drying out
the intrinsic protection may be impaired.
•
Do not lift the Rotator by the Tray.
•
Risk of Binding: Assure that other equipment close to the Rotator
does not cause interference with the tray movement.
•
Connect only to a power supply that provides a safety ground
terminal.
•
Before moving, disconnect at the power supply socket. Do not
remove the plug from the rear of the unit.
•
Ensure that the power switch is easily accessible during use.
•
Do not block or restrict ventilation slots.
•
If liquid is spilled on top of the unit, disconnect it from the power
supply and have it checked by a competent person.
•
It is the user’s responsibility to carry out the appropriate
decontamination if hazardous material is spilled on or inside the
equipment.
•
This product must be used with an UL / CSA Certified power
supply cord set rated for a minimum temperature of 90˚C.
•
The Power Cord supplied with the unit is the disconnect means.
•
Do not position the unit so that it is difficult to operate the
disconnecting means.
•
Caution should be taken when operating the Orbitron V with
heavy loads at high speed. Always start the Orbitron V at low
speed and gradually increase the speed to the desired setting.