Boekel Scientific Analog Incubators - Manual (Page 6)

Page 6 of 12
3.0 Assembly
3.1 Unpacking the Unit
Remove the packing materials carefully, and retain for future shipment or
storage of the unit. Inspect for damage. Report all shipping damage to
the carrier immediately. Shipping damage is covered by the carrier and
repair/replacement for shipping damages must be coordinated through the
carrier. Complete and return the Warranty Registration Card. Packages
should contain:
• Incubator
• Power line cord
• Operating Instructions
• Shelves and Shelf Mounting Brackets
0.5 Cu. Ft. – 1 Shelf with 4 Shelf Brackets
1.4 Cu. Ft. – 2 Shelves with 8 Shelf Brackets
2.5 Cu. Ft. – 2 Shelves with 8 Shelf Brackets
5.0 Cu. Ft. – 3 Shelves with 12 Shelf Brackets
• Timer
3.2
Installation
Place the incubator on a flat and stable surface, preferably away from
drafts. Insure that the surface on which the unit is placed will withstand
the radiated heat produced by typical laboratory incubators. Fit the power
line cord into the IEC power socket on the rear of the unit. Plug the power
cord into a power supply that matches the voltage listed on the
serial/electrical information label on the rear of the unit.
Insert the Shelves at the desired heights. Refer to the sketch below for
proper shelf mounting bracket installation.
SHELF INSTALLATION DIAGRAM
SHELF
BRACKET
INN
E
R
WAL
L
STEP #1
STEP #3
SHELF
STEP #2
90°
INN
E
R
WAL
L
INN
E
R
WAL
L
WAL
L
INN
E
R