Boekel Scientific Analog Incubators - Manual (Page 11)

Page 11 of 12
On the 115V 2.5 Cu. Ft. and the 5.0 Cu. Ft. sizes there are additional
fuses located on the rear of the incubator. Refer to the sketches below for
the fuse information. The replacement fuses must be 5mm x 20mm quick
acting, rated at 250V. Before replacing any of these fuses turn the power
switch to the off (O) position and disconnect the unit from the power
supply. Use a flat blade screw driver to remove the fuse carrier. Replace
the fuse with the value listed and replace the fuse carrier.
Outlet Fuses
4AF
2.5 Cu. Ft. Incubator Rear Panel
5.0 Cu. Ft. Incubator Rear Panel
Incubator Fuses
6.3AF
4AF, 250V
REPLACE ONLY WITH THE SAME TYPE AND RATING OF FUSE
CHAMBER
FUSES FOR
REQUIRED
TWO FUSES
OUTLET
TWO FUSES
REQUIRED
4AF, 250V
FUSES FOR
CHAMBER
OUTLET
REQUIRED
FUSES FOR
INCUBATOR
TWO FUSES
6.3AF, 250V
Incubator Fuses
3.15AF
4AF, 250V TWO FUSES
REQUIRED
TWO FUSES
Outlet Fuses
4AF
REQUIRED
OUTLET
CHAMBER
FUSES FOR
TYPE AND RATING OF FUSE
REPLACE ONLY WITH THE SAME
INCUBATOR
FUSES FOR
3.15AF, 250V
9.0 Warranty
When used in laboratory conditions and according to these operating
instructions, Boekel warrants this product to be free of defective material
and workmanship for a period of two years from the date of manufacture.
The liability of Boekel for any defective equipment during the warranty
period shall be limited to the repair of such equipment or replacement
thereof without charge for parts or labor.
10.0 Service
It is required to obtain a Returned Material Authorization (RMA) number
before any Boekel products are returned for any reason. A
Decontamination Certificate must be completed, signed by the user, and
returned to Boekel Scientific prior to receiving the RMA number. Please
be sure to mark the outside of the returned goods package with this RMA
number to ensure prompt handling.