AXEON AT-Series - Manual (Page 8)

AT – Series User’s Manual
MKTF-205
NOTE: IT’S RECOMMEND
SYSTEM IN ACCORDANCE WITH LOCAL AND NATIONAL ELECTRICAL CODES
(NEC).
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, THE
INCOMING POWER SUPPLY MUST INCLUDE A PROTECTIVE EARTH GROUND.
AT-Series systems are typically controlled with a liquid level switch in a storage tank.
The liquid level switch turns the system on when the water level in the tank drops, and
off when the tank is full. Liquid level switches can be obtained by your local dealer or
distributor. If a liquid level switch is to be used, install it at this time.
PRE-FILTRATION
AT-Series systems are supplied with a 5 micron sediment filter and a 10 micron car
block. Change the cartridge
between the two pre-filters. Ask your local deale
systems, if required.
NOTE: THE SYSTEM MUST BE OPERATED ON FILTERED WATER ONLY.
PUMP
The pump type used on the AT
pumps are also available as an option
If any damage occurs to your system
your local dealer or distributor and inform them of your system
MOUNTING
The free standing system should be bolted down in compliance with local regulation
standards or securely fastened.
AT-Series reverse osmosis systems come pre
HF1 High Flow Low Energy membranes, unle
membrane element performance characteristics are listed
8
RECOMMENDED THAT A LICENSED ELECTRICIAN WIRE YOUR
SYSTEM IN ACCORDANCE WITH LOCAL AND NATIONAL ELECTRICAL CODES
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, THE
INCOMING POWER SUPPLY MUST INCLUDE A PROTECTIVE EARTH GROUND.
systems are typically controlled with a liquid level switch in a storage tank.
The liquid level switch turns the system on when the water level in the tank drops, and
Liquid level switches can be obtained by your local dealer or
distributor. If a liquid level switch is to be used, install it at this time.
systems are supplied with a 5 micron sediment filter and a 10 micron car
block. Change the cartridge once a month or when a 10-15 psi differential e
filters. Ask your local dealer or distributor about Pre
NOTE: THE SYSTEM MUST BE OPERATED ON FILTERED WATER ONLY.
type used on the AT-Series systems is brass rotary vane pump
as an option in stainless steel.
If any damage occurs to your system’s pump, a re-build kit may be available. Contact
your local dealer or distributor and inform them of your system and pump model
standing system should be bolted down in compliance with local regulation
standards or securely fastened.
MEMBRANE ELEMENTS
everse osmosis systems come pre-loaded with Thin Film Composite (TFC)
High Flow Low Energy membranes, unless otherwise specified. General
membrane element performance characteristics are listed on the next page.
06/12
THAT A LICENSED ELECTRICIAN WIRE YOUR
SYSTEM IN ACCORDANCE WITH LOCAL AND NATIONAL ELECTRICAL CODES
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, THE
INCOMING POWER SUPPLY MUST INCLUDE A PROTECTIVE EARTH GROUND.
systems are typically controlled with a liquid level switch in a storage tank.
The liquid level switch turns the system on when the water level in the tank drops, and
Liquid level switches can be obtained by your local dealer or
systems are supplied with a 5 micron sediment filter and a 10 micron carbon
15 psi differential exists
r or distributor about Pre-Filtration
NOTE: THE SYSTEM MUST BE OPERATED ON FILTERED WATER ONLY.
ary vane pumps. These
build kit may be available. Contact
and pump model.
standing system should be bolted down in compliance with local regulation
loaded with Thin Film Composite (TFC)
se specified. General
on the next page.