AXEON AT-Series User Manual
Page 7

AT – Series User’s Manual
MKTF-205
NOTE: FEED LINE MUST BE
PERMEATE (PRODUCT WATER) CONNECTION
Locate the 3/8” tubing labeled permeate and attach to storage tank
permeate water can flow freely
irreversible damage to the membrane elements.
the holding tank with PVC fittings, or other FDA approved materials
material being used does not di
CAUTION THE PH OF THE REVERSE O
TYPICALLY BE 1-2 POINTS LOWER THAN THE FEED WATER PH. A LOW PH CAN
BE VERY AGGRESSIVE TO SOME PLUMBING MATERIALS SUCH AS COPPER
PIPING.
CONCENTRATE (WASTE WATER) CONNECTION
Locate the 3/8” tubing labeled
concentrate line to an open drain in a free and unrestricted manner (no backpressure).
CAUTION: ANY RESTRICTIONS OR BLOCKAGE IN THE DRAIN LINE CAN
CAUSE BACKPRESSURE, WHICH WILL
PRESSURE. THIS CAN RESULT IN DAMAGE TO THE SYSTEM’S MEMBRANES AND
COMPONENTS.
ELECTRICAL
The motor used on the AT-
in 110/220 Volt 50/60 Hertz 1 P
electrical cord. 110V model
Ensure that the electrical circuit supplying the system is compatible with the
requirements of the specific AT
7
NOTE: FEED LINE MUST BE MINIMUM 1/2” INCH.
PERMEATE (PRODUCT WATER) CONNECTION
labeled permeate and attach to storage tank.
permeate water can flow freely with no backpressure. Backpressure can cause
damage to the membrane elements. The 3/8” permeate line
with PVC fittings, or other FDA approved materials.
material being used does not dissolve into the permeate water.
THE PH OF THE REVERSE OSMOSIS PERMEATE WATER WILL
2 POINTS LOWER THAN THE FEED WATER PH. A LOW PH CAN
BE VERY AGGRESSIVE TO SOME PLUMBING MATERIALS SUCH AS COPPER
CONCENTRATE (WASTE WATER) CONNECTION
labeled concentrate and attach the tubing to a
to an open drain in a free and unrestricted manner (no backpressure).
CAUTION: ANY RESTRICTIONS OR BLOCKAGE IN THE DRAIN LINE CAN
CAUSE BACKPRESSURE, WHICH WILL INCREASE THE SYSTEM’S OPERATING
PRESSURE. THIS CAN RESULT IN DAMAGE TO THE SYSTEM’S MEMBRANES AND
-Series systems is a carbonator motor. The motor is
in 110/220 Volt 50/60 Hertz 1 Phase. Each AT-Series system is equipped with a 5 foot
110V models are equipped with a plug.
nsure that the electrical circuit supplying the system is compatible with the
uirements of the specific AT model you are installing.
06/12
. Ensure that the
Backpressure can cause
3/8” permeate line can be run to
. This is so the
SMOSIS PERMEATE WATER WILL
2 POINTS LOWER THAN THE FEED WATER PH. A LOW PH CAN
BE VERY AGGRESSIVE TO SOME PLUMBING MATERIALS SUCH AS COPPER
a drain. Run the
to an open drain in a free and unrestricted manner (no backpressure).
CAUTION: ANY RESTRICTIONS OR BLOCKAGE IN THE DRAIN LINE CAN
INCREASE THE SYSTEM’S OPERATING
PRESSURE. THIS CAN RESULT IN DAMAGE TO THE SYSTEM’S MEMBRANES AND
The motor is available
system is equipped with a 5 foot
nsure that the electrical circuit supplying the system is compatible with the