Antari W-530D - Manual (Page 9)

Press the button “A”, to emit fog. The button “A” has the same function as the
button VOLUME on the control panel, i.e. the fog output depends on the setting
of menu item » Volume Output« . The display indicates » Volume« followed by
the defined value or » NONSTOPBURST« when continuous fog output was
selected. As additional control, the blue LED light. To stop the fog output, press
the button “B”.
* Receiver:
The receiver is tested and pre-attached to the rear panel of each W-series
model. Please do not try to remove it. The receiver responds to up to 5
different transmitters that are registered with the machine. The included
transmitter has been registered to the machine before shipment. It can be
directly operated without any start-up setting.
- Registering transmitters
To operate the machine with a different transmitter than the included one, or
to operate it with up to 5 different transmitters, each transmitter must be
registered first. For this purpose, turn on the machine. When the display
indicates » Wireless Detect…« , press the button “A” 1 second on each
transmitter. Thus the previous transmitters are cleared from the memory of
the receiver. The setting must be completed within 15 seconds at indication
» Wireless Detect…« .
If no transmitter is registered when the machine is switched on, the memory
of the receiver will keep the record of the previous operation.
Setting Example 1:
In order to register several transmitters with a machine, turn on the machine.
When the display indicates » Wirele
ss Detect… « , press the button “A”1 second
on each transmitter within 15 seconds to establish the signal transmission.
Setting Example 2:
In order to use 1 transmitter to control 2 or more machines, turn on the