Antari W-530D - Manual (Page 7)

Note:
When W-DMX function is activated, the connection status will be shown on
display by below symbols.
Status of W-DMX connection Symbol on the Liquid Crystal
Display
Transmitter assigned, DMX signal
received
●
Transmitter assigned, No DMX signal
◎
Transmitter link lost or linking to
transmitter
⊙
Transmitter not assigned
○
▪ Setting W-DMX 512 address
When W-DMX function is activated, press button MENU until the display indicates
» W-DMX Address: 001« . Use the buttons UP and DOWN to set the machine to
the same address as on your W-DMX console.
▪ Resetting W-DMX connection
When W-DMX function is activated, press button MENU until the display indicates » W-
DMX Reset OFF« . Use the buttons UP and DOWN to activate the resetting:
delete previous W-DMX connection and relink. Once the deletion and relink
are done, the dispay indicates » W-DMX Reset OFF« again.
▪Switching the run last setting function on and off
Press the button MENU until the display indicates » Run Last Setting ON« .
Use the buttons UP and DOWN to deactivate the fun last setting function
(indication » Run Last Setting OFF« ) and to reactivate it (indication » Run
Last Setting ON« ).
- Continuous operation