Antari W-530D - Manual (Page 8)

Press the button VOLUME, to activate continuous fog output. The display
indicates » Volume Output« followed by the value that was set in menu item
» Volume Output« or » NONSTOPBURST« when continuous fog output was
selected. To stop the fog output, press STOP button.
NOTE:
When a fog output volume higher than 30 % was set for continuous
operation, the fog machine occasionally needs to stop the fog output to
reheat. When » NONSTOPBURST« was selected, the fog machine adjusts
the fog output volume and heater temeperature automatically and does
not need to stop to reheat.
- Timer operation
In the timer mode, the fog machine will automatically emit fog. The time
intervals, duration and fog volume depend on the corresponding menu
settings. Press the button TIMER to activate the timer mode. The display
indicates the set time interval. The unit counts down to 0 seconds and emits
fog. To deactivate the timer mode, press STOP button.
W-1 Wireless Remote
The wireless remote control system W-1 consists of a transmitter equipped with
two buttons for fog on and off, and a receiver pre-attached to the rear panel of
each W-series model.
* Transmitter:
With the transmitter it is possible to emit fog via radio over a distance of up to
50 meters.The transmitter is compatible to any receiver of the W-series and
can control an unlimited number of machines in parallel.