Antari W-530D - Manual (Page 10)

machines at the same time.When the displays indicate » Wireless Detect…« ,
press the button “A” 1 second on the transmitter within 15 seconds to
establish the signal transmission.
- Battery change on the transmitter
If the range of the transmitter decreases, the battery is probably exhausted
and must be replaced. For this purpose, take off the housing cover and remove
the used battery. Insert a fresh 12 V battery, type 27A as indicated in the
battery compartment and refit the housing cover.
DMX Connector Pin Assignment
The machine provides 3 or 5 pin XLR connector for DMX connection. Diagram
below indicate pin assignment information
2
3
1 1
3
2 5 3 1
4 2
1 3 5
2 4
3 5 pinXLR
Pin Function
1 Ground
2 Data-
3 Data+
DMX512 Settings
Channel A
0 - 5 = off (no output)
6 - 255 = output volume control (1 - 100 % output)
Both models are equipped with a DMX512 system. For connecting a DMX
controller, 3-pin and 5-pin male-female XLR connections are provided at the
back of each machine. The machines use one control channel for adjusting the
output volume. The channel has a DMX value range of 0 to 255. After
connecting a DMX controller, timer functions such as output duration and
interval can be programmed using the DMX controller or the DMX control
software. The machine cannot be controlled via the built-in control panel
northe W-1 wireless remote anymore. By using the DMX protocol, fog
machines, lighting effects, and other special effects machines can be
interconnected and easily controlled.