Antari W-715 - Manual (Page 7)

7
Duration Time Setup - Press the [Menu] button until the LCD screen displays “ Duration
Set ” and press the ▲ or ▼ button to set the duration time from 2-15 seconds.
Output Volume Setup - Press [Menu] until the LCD screen displays “ Timer Output ” and
press the ▲ or ▼ button to set the output percentage from 50-100%.
After finishing the above setting, go back to the main screen by pressing the [Stop] button.
To activate Timer Mode , press the [Timer] button below the display. To deactivate Timer
Mode , press [Stop] button.
Volume Operation
To operate the machine in Volume Mode , the output volume under Volume Mode must be
set first:
Output Volume Setup - Press the [Menu] button until the LCD screen displays “ Volume
Output ” and then press the ▲ or ▼ button to set the output percentage from 50-100%.
After finishing the above setting, go back to the main screen by pressing the [Stop] button.
To activate Volume Mode , press the [Volume] below the display. To deactivate Volume
Mode , press the [Stop] button.
Note: In Volume Mode, the machine emits fog continuously until a re-heat is needed.
2-Second Jet Operation
To activate 2-Second Jet Mode , press the [Menu] button until the LCD screen displays
“ 2-Second Jet Output ” and then press the ▲ or ▼ button to activate or deactivate
2-Second Jet Mode . Once the 2-Second Jet Mode is activated, the main screen will keep
showing “ 2-Sec Jet Mode ” . Press the [Volume] button and the fog will be emitted for 2
seconds with maximum output (100%).
DMX Operation
Making the DMX Connection
– Connect machine to a DMX controller or to one of the
machines in the DMX chain. The machine uses an 3-pin and 5-pin XLR connector for DMX