Antari W-715 User Manual
Page 10
10
Notes:
1.
Once the wireless remote control function is activated, the letter
“
W
”
will be displayed
on the LCD screen.
2.
Once the wireless remote control function is activated, the LCD screen will display
“
Wireless Detect
…”
each time the machine is turned on; this allows new registration.
Every new registration overwrites the previous memory.
3.
One machine can be controlled by up to 5 transmitters while one transmiter can be
registered to an unlimited number of machines.
4.
Battery used in transmiter: type A27S 12V.
5.
In
2-Second Jet Mode
, pressing the button (A or B) on the trasmitter will emit fog for 2
seconds with maximium output (100%).
Power Saving
Keep pressing the [Stop] button for 3 seconds; the LCD screen will display a
countdown of 60 seconds. After the countdown, the machine will go into sleep
mode. To wake up the machine again, press any button.
When the machine is idle for 15 seconds, the backlight of the LCD screen becomes
dim. To light up again the LCD screen, press any button.
When DMX connector is disconnected from the machine, the machine will go into
sleep mode, and when the DMX connector is re-connected to the machine again,
the machine will be woken up.
Fluid
Only use
Antari FLC water-based fluid
for the W-715 Fogger. The machine is tested and
calibrated with this fluid to achieve the best output performance. Warranty will be void if any
other type of liquid is used, improper use of liquid may lead to machine failure and
malfunction.
Service and Maintenance
Do not allow the machine to become contaminated.
Remove dust from air vents with air compressor, vacuum or a soft brush.
Only use a damp cloth to clean the casing.
Before storing run distilled water through the system to help avoid condensing the