Antari HZ-500 - Manual (Page 9)

9
*Note 3: If the displays shows »Out Of Order«, the machine's internal temperature is too high and as a
result the thermostat has been set off to shut-down the hazer.
If you experience this problem, please check two points as described below:
1. Check if the mesh (filter) outside the ventilation fan is clean and without debris. If the mesh
is covered by dust or obstruction (such as paper, plastic bag, etc.), the machine is put
into a very poor ventilation condition and causes the internal temperature to rise.
Therefore, it is strongly suggested to clean the mesh regularly.
2. Check the surrounding temperature at the hazer's place of installation. If the temperature of
the surrounding environment is too high, please move the machine to a cooler place
with better ventilation.
*Note 4: Before moving the machine, it is important to replace the nozzle by the black rubber stopper.
Please make sure it fits tightly in order to prevent spillage of the HZL-1 Haze liquid in case the
machine is turned upside down during the transportation. Before reusing the machine, please put
the nozzle back on the outlet and make sure it is properly installed.
DMX Connector Pin Assignment
The machine provide 3 or 5 pin XLR connector for DMX connection. Diagram below indicate pin
assignment information